killood.blogg.se - How to replace a dishwasher drain line

Plug the dishwasher back in and turn the power back on.Turn the water supply back on and reattach the wastewater hose.Realign the lower access panel and screw back in the screws to secure it in the dishwasher.Reconnect the water supply line onto the inlet valve, and secure it by tightening on the elbow fitting.Make sure that the drain hose is elevated above the connection point. Reconnect the hoses and plugs back to their correct positions.Reattach the mounting brackets to the countertop or cabinet.Adjust the front leveling legs and rear leveling rod if required to ensure the dishwasher is level.Pull the hoses and cords out through the holes. Make sure that the hoses and cords are threaded into the holes in the cabinet – then push the dishwasher back into it.Reattach the cover onto the junction box, and secure it with the screw.Remove the object keeping the dishwasher elevated, reattach the wires back to how they were before, and secure them with the wire nuts.Once in the correct position, you can thread and tighten the strain relief nut. Thread the power supply cord back into the junction box as well as the strain relief.Prop the dishwasher back up 3-4inches on an angle with a piece of wood or another object.You can now pull the dishwasher up to an upright position.Reattach the “rear leg adjusting rod” back into the correct position.Align the lower panel in the correct position, and then snap it back into place.Place it into the sump and twist it clockwise until the tab clips in.

Now that you’ve successfully removed the old pump, the first thing to do is to reattach the wire connector to the new pump.Disconnect the wire connector from the drain pump, and take it out of the dishwasher.You can remove it by holding the tab on it and then turning it counterclockwise. Now you will have access to the drain pump.Remove the bottom panel by unclipping it and taking off the rear leg adjusting rod.Place a towel behind the dishwasher and then tip the dishwasher down onto it so that it’s resting on the back panel.

Unthread the strain relief nut and then detach the strain relief and the connected wires from the junction box.

You might need somebody to help you lift it while you place the object underneath it.

Lift the dishwasher from the front about 3-4 inches and place a piece of wood or similar item underneath the dishwasher to keep it in a tilted-up position.

When open, disconnect the wires by undoing the wire nuts (make sure you note which wires go where for when you have to put them back together again). You can do this by unthreading the screws that hold the junction box cover in place.

Remove the power supply cord from the junction box.

When pulling the dishwasher out, make sure that the water hoses can come out with it and are not stuck.

If required, adjust the dishwasher legs so that you can pull it out from its position.

Open the dishwasher door and unthread the two screws that secure the mounting bracket to the countertop or cabinet (if applicable).

Disconnect the drain hose from the sink drain or garbage disposal unit.

You might want to put a towel down underneath it, as water may come out of the waterline when you remove it.

Unscrew the rest of the elbow fitting until the water supply line is disconnected.

Use a pair of channel lock pliers to loosen the elbow fitting that connects the water supply line to the water inlet valve.

Once removed, set the panel aside out of the way. You’ll need to unthread the two screws that are holding it in place.

The first thing to do is to remove the lower access panel.

Start by disconnecting the power at the wall.

This guide covers most models of Electrolux dishwashers, including: Simply follow our step-by-step instructions below to remove the faulty drain pump and then reinstall the new one. Do you need to replace the drain pump in your Electrolux dishwasher? The good news is that it’s a pretty straightforward repair to make, so it doesn’t require a high level of technical knowledge.